Jumbo Jet Paper Airplane 
Folding Instruction


Click here to get a patterned artwork sheet.


Step 1

Step  2
Step 1
Start with an 8 1/2"x11"  paper or download the patterened sheet and cut off the boundary part. With patterned side down, fold  paper in half vertically.

Step 2
Cut Line C as shown. This part will be rudder. Then unfold the paper.


Step 3

 
Step 4
Step 3
Fold lower part up along line A

Step 4
Bring both sides to the center line.


Step 5

Step 6
Step 5
Crease bottom center flaps as shown.

Step 6
Unfold left top layer while pressing the second layer(Green Arrow). See Figure 7 for this folding.

.
Step 7

 
Step 8
Step 7
This fold creates a triangle pocket.

Step 8
Then repeat steps 6, 7 for the right side. Flip over the model.

 
Step 9

Step 10

Step 9
Fold down the upper part along line B.

Step 10
Bring the top layer's both side edges to the center line.

Step 11

Step 12
Step 11
Make a mountain fold along the center line.

Step 12
Fold the top layer along vertical line as shown.

Step 13


Step 14

Step 13
Crease along line D and E.

Repeat steps 12 and 13 for the other side wing.

Step 14
Adjust creases of the model to match the diagram. Make three more foldings for nose part.


Step 15



Step 15
 
Adjust creases until the model has this profile.
Your Jumbo Jet is ready to take off.

Copyright © 2011 (pending) by Kyong H. Lee.  All rights reserved.